Tork Craft | Annular Hole Cutter HSS 45 X 55mm Broach Slugger Bit Cordless_Pencil Grinder when the turning point is

when the turning point is at the top of the grinder

7 Total length (G) mm 45

High Durability

rigid abrasive sponge

Powerful enough to tighten M20 bolts (30mm nuts) thanks to 400Nm torque

Tork Craft | Annular Hole Cutter HSS 45 X 55mm Broach Slugger Bit Cordless_Pencil Grinder when the turning point isAnnular Hole Cutter HSS 45 X 55mm Broach Slugger Bit One way to avoid dimpling and deburring while making holes in tube and pipe is to use annular cutters. Because annular cutters are hollow on the inside, there is no dead zone resistance to overcome. Using a twist drill to make holes in pipe or tubing can prompt concerns about the hole roundness, location accuracy, hole finish, chip extraction, burrs, and drilling duration. The focal point of these